Full CAT6

Specification with moulded boots & unique connector latch protection Snagless strain relief prevents damage

...

Full CAT6

Specification with moulded boots & unique connector latch protection Snagless strain relief prevents damage

...

Full CAT6

Specification with moulded boots & unique connector latch protection Snagless strain relief prevents damage

...

Full CAT6

Specification with moulded boots Snagless strain relief prevents damage to the RJ-45 latch during installation

...

Full CAT6a

Specification with moulded boots & unique connector latch protection Low Smoke Zero Halogen PIMF (Pairs

...

This superb Display Port cable benefits from advanced design & construction to provide the best possible performance & reliability. ...

DVI-D Single Link Cable For use as an LCD monitor cable or DVI projector cable Single Link connection supports resolutions of up to 1920 x 1200 Connectors: DVI-D Single Link Male to DVI-D Single Link Male 10 Year Warranty ...

Features of the RF-BLOK shielded design: Reduced interference from one piece EMI (Electromagnetic Interference)/RFI (Radio Frequency Interference) shield Increased insulation resistance up to 25% No soldering requirements as interconnect design needs no 360 degree soldering
- eliminating the possibility of human error and/or cracking of the solder that causes grounding intermittence & the use of the most hazardous waste material
- soldering flux Tight fit of internal wires as there is no inner mould No requirement of ferrite cores as signal loss & degradation are greatly reduced giving enhanced signal sharpness. Without the ferrite cores the cable is less stressed & more flexible Smaller overall

Dimensions which allows more room behind the host or peripheral Increased connector & mating strength
- the 4 point reinforcement tabs on the RF-BLOK, attached to the connector, strengthens the pair as one Important! Please note that cable lengths over 7.5m are above the recommended length laid down by the DDWG organisation who developed the

Specification. This factor also depends on the hardware combination of graphics card & monitor as to how far this distance can be exceeded.






...

Features of the RF-BLOK shielded design: Reduced interference from one piece EMI (Electromagnetic Interference)/RFI (Radio Frequency Interference) shield Increased insulation resistance up to 25% No soldering requirements as interconnect design needs no 360 degree soldering
- eliminating the possibility of human error and/or cracking of the solder that causes grounding intermittence & the use of the most hazardous waste material
- soldering flux Tight fit of internal wires as there is no inner mould No requirement of ferrite cores as signal loss & degradation are greatly reduced giving enhanced signal sharpness. Without the ferrite cores the cable is less stressed & more flexible Smaller overall

Dimensions which allows more room behind the host or peripheral Increased connector & mating strength
- the 4 point reinforcement tabs on the RF-BLOK, attached to the connector, strengthens the pair as one Important! Please note that cable lengths over 7.5m are above the recommended length laid down by the DDWG organisation who developed the

Specification. This factor also depends on the hardware combination of graphics card & monitor as to how far this distance can be exceeded.






...

4 Way RJ-11 Male to 4 Way BT Telephone Male Straight-through wiring 10 year warranty ...