Features of the RF-BLOK shielded design: Reduced interference from one piece EMI (Electromagnetic Interference)/RFI (Radio Frequency Interference) shield Increased insulation resistance up to 25% No soldering requirements as interconnect design needs no 360 degree soldering
- eliminating the possibility of human error and/or cracking of the solder that causes grounding intermittence & the use of the most hazardous waste material
- soldering flux Tight fit of internal wires as there is no inner mould No requirement of ferrite cores as signal loss & degradation are greatly reduced giving enhanced signal sharpness. Without the ferrite cores the cable is less stressed & more flexible Smaller overall

Dimensions which allows more room behind the host or peripheral Increased connector & mating strength
- the 4 point reinforcement tabs on the RF-BLOK, attached to the connector, strengthens the pair as one




...

Features of the RF-BLOK shielded design: Reduced interference from one piece EMI (Electromagnetic Interference)/RFI (Radio Frequency Interference) shield Increased insulation resistance up to 25% No soldering requirements as interconnect design needs no 360 degree soldering
- eliminating the possibility of human error and/or cracking of the solder that causes grounding intermittence & the use of the most hazardous waste material
- soldering flux Tight fit of internal wires as there is no inner mould No requirement of ferrite cores as signal loss & degradation are greatly reduced giving enhanced signal sharpness. Without the ferrite cores the cable is less stressed & more flexible Smaller overall

Dimensions which allows more room behind the host or peripheral Increased connector & mating strength
- the 4 point reinforcement tabs on the RF-BLOK, attached to the connector, strengthens the pair as one




...

DVI-I Single Link Digital + Analogue Cable For use with all standard digital TFT (Thin Film Transistor)/LCD (Liquid Crystal Display) Flat Panel Displays Single Link connection supports resolutions of up to 1920 x 1200 Connectors: DVI-I Single Link Male to DVI-I Single Link Male Also available in lengths of 1, 3 & 5m. 10 year warranty ...

25 Way D Male to 36 Way Centronics Male IEEE 1284 compliant Fully moulded 10 year warranty ...

e SATA 7 Pin Male to e SATA 7 Pin Male Supports SATA II speeds of up to 3 Gbit/sec ...

European Mains Plug to IEC C7 Figure 8 Connector Socket 100% electrical & mechanical inspection Fully moulded 10 year warranty ...

This external e SATAp cable integrates both data & power signals into a single lead. It connects an external SATA hard disk or similar device to an e SATAp port. It can connect both 2.5" & 3.5" hard disks as it provides both +5VDC & +12V DC so can be used with both desktop & laptop computers (see note below). This cable is compatible with the latest generation of computers & interface cards that support power over e SATA. The cable may be used in conjunction with our 2 Port Power over e SATAp +USB PCI Express card & Power e SATA & USB (Universal Serial Bus) 2.0 Adapter Card. Note: Laptops typically supply up to 5V from the e SATA port, which is suitable for use with most 2.5" HDDs & SSDs; desktop computers typically supply up to 12V, which is suitable for both 2.5" & 3.5" drives. Please check that your computer's e SATA interface port supports power before using this cable. ...

4 Way RJ-11 Male to 4 Way BT Telephone Male Crossed-over wiring 10 year warranty ...

4 Way RJ-11 Male to 4 Way BT Telephone Male Straight-through wiring 10 year warranty ...

2 x LC Fibre Optic Male to 2 x LC Fibre Optic Male Compatible with all standard fibre optic equipment & connectors Full duplex 50/125m type fibre Zip twin, LS0H, Multimode cable Ceramic connectors ensure low signal loss & high reliability Total immunity to electrical & electromagnetic interference (EMI) Insertion Loss: ...