Note: This POE Injector may also be used in conjunction with our POE Splitter (sold separately) for powering non POE devices such IP cameras, access points & wireless routers.
This POE Injector will work with any power over ethernet devices that operate with a supply voltage of 48V DC. When it is used in conjunction with our POE Splitter you can power any non POE devices such as, IP cameras, access points & wireless routers etc. Simple to install & setup, it allows both power & data to be transmitted over a single network cable.
Package Contents:
Po E Injector
PSU 48V, 0.83A
UK power cable 1.8m
User manual ...
Please Note: This POE Splitter can used in conjunction with our POE Injector (sold separately) or with any suitably compliant POE switch.
Our POE Splitter will work with all network devices that operate with a supply voltage of 5V, 9V or 12 Volts DC when used in conjunction with our POE Injector. Simple to install & setup, it allows for both power & data to be transmitted over a single network cable. Suitable for use with IP cameras, Access points Hubs & Switches.
Includes: a DC power cable 5.5mm outer / 2.6mm inner, 0.5m
Package Contents:
Po E Splitter
DC power cable
User manual ...
For optional use with LINDY 2.5" External Drive Housings
Can also be used with our 4 Port USB (Universal Serial Bus) 2.0 Smart Hub (42998)
This PSU should be used -
when installing hard drives that require more than 400/500m A
when connecting the USB (Universal Serial Bus) 2.0/ Fire Wire Drive Housing to a 4 Pin Fire Wire port. This is because, unlike 6 Pin Fire Wire ports, the 4 Pin port does not provide the connections for bus-powered devices
Input: 200-240V AC ~ 50 Hz 0.4A
Output: Regulated, 5V DC - 2.6A
Connector: Round, 1mm inner diameter, 3mm outer diameter, positive (+) on centre contact ...
'PP3' Type 9V Alkaline Batteries
Suitable for use with toys, portable tape & CD players, clocks & radios, electronic games, smoke alarms, flashlights etc.
Sold in packs of 10
AAand AAAbatteries also available.
Duracell Procell alkaline batteries are manufactured to the highest standards & feature a new enhanced formula which offers an advanced longer life. Conveniently packaged in packs of 10. ...
Pre-assembly boots must be used before crimping the RJ-45 connector onto the cable
For cable diameters up to 6mm
Great for identification at patch panels ...
Pre-assembly boots must be used before crimping the RJ-45 connector onto the cable
For cable diameters up to 6mm
Great for identification at patch panels ...
Pre-assembly boots must be used before crimping the RJ-45 connector onto the cable
For cable diameters up to 6mm
Great for identification at patch panels ...
Pre-assembly boots must be used before crimping the RJ-45 connector onto the cable
For cable diameters up to 6mm
Great for identification at patch panels ...
Pre-assembly boots must be used before crimping the RJ-45 connector onto the cable
For cable diameters up to 6mm
Great for identification at patch panels ...
Ideal for use with our Duracell Simply 4 Battery Charger. ...
Archived Product
Pre-assembly RJ-45 Strain Relief Boot, Black (10 Per Pack)
Pre-assembly boots must be used before crimping the RJ-45 connector onto the cable
For cable diameters up to 6mm
Great for identification at patch panels
RIP - This product is no longer available on our network. It was last seen on 13.02.2012
This page now acts as a permanent archive for this product. Add more information using the comments box below to ensure it can still be found by future generations.
Use our search facility to see if it is available from an alternative contributor.
Pre-assembly boots must be used before crimping the RJ-45 connector onto the cable
For cable diameters up to 6mm
Great for identification at patch panels
Reviews/Comments
Add New
Intelligent Comparison
Archived Product
Pre-assembly RJ-45 Strain Relief Boot, Blue (10 Per Pack) LINDY Electronics